View unanswered posts | View active topics It is currently Thu Jun 21, 2018 12:15 am



Reply to topic  [ 1 post ] 
 ****How To Guide... Bypassing A/C on 3.8L F Car**** 
Author Message
CCFBG Club Member
User avatar

Joined: Mon Feb 20, 2006 6:15 pm
Posts: 1641
Location: Niagara Falls
Reply with quote
Post ****How To Guide... Bypassing A/C on 3.8L F Car****
First off locate the proper pulley to replace the idler wheel below the Alt and above the A/C Compressor,you will also need a shorter belt Gates #K060806 does the trick.

I used a tensioner pulley off of a 4.3L V6 truck engine from the wrecking yard.

Remove the old "smoothy"pulley.

Pull the white plastic cover cap back on the top heater hose line.

Use a file or a dremel tool to grind down the ridge on the aluminum housing being careful not to damage the heater hose connector.

I used a hand file and it took less than 5 minutes to get it done.

You can put the white cover back now.

Now you can install your new or used pulley,if your using the 4.3L pulley there is a small spacer that GM uses to make it universal as they use a smaller bolt on that application.

Discard the spacer you don't need it.

Now use your original bolt and tighten her up.

Re route your new belt and check to see if there is enough clearance for the belt going by the heater hose outlet.

Now fire it up and see if it rubs,its close but an 1/8 of an inch is plenty.

Now take her for a test spin and blow the doors off that mini van with your free 5 hp :lol:

_________________
2010 SIM 2SS/RS A6
13.08 at 107.82


Tue Apr 10, 2012 7:25 pm
Profile WWW
Display posts from previous:  Sort by  
Reply to topic   [ 1 post ] 

Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by STSoftware for PTF.